The stage one motorcycle kit with components listed below is $3895.  This combination has produced over 280 rear wheel horsepower on PUMP gas at ONLY 8 lbs. of boost!  Higher boost levels can be accomplished by replacing the stock injectors. We are constantly performing R&D on the Dyno to obtain the most power with minimal boost levels for performance and reliability. 

The kit uses the following components-

Mitsubishi Super 16G or 20G w/ 10 or 15psi waste gate actuator
304 .065 polished stainless steel header
304 .049 polished stainless steel boost tubes
304 .049 polished stainless steel dump pipe
6061 polished aluminum plenum
High pressure CPE fuel line with AN fittings
Braided stainless steel oil feed to turbo
Aeromotive billet fuel filter with replaceable filter
Accel 500 horsepower fuel pump
BEGI Billet fuel pressure regulator
Aluminum bracket to hang fuel pressure regulator from throttle bodies
High temp. Silicone connectors with TRUE liner style clamps
APE High Volume Oil pump gear with circlip
Silicone vacuum/pressure hose to replace all OEM hose
Ceramic coated exhaust side of turbo 
Stainless steel PAIR valve block offs

Installation-

The kit installed with fuel and ignition mapping on the Dyno and no engine top end 
work $4995.00. 

Additional options include-

Dynojet Power Commander PCIIIr  $399.95
Full exhaust system from $325
Super sequential blow off valve $174.99
Autometer liquid filled boost gauge $55
Complete pre-assembly of turbo kit, cuts customer install time by 75%.  $200
Aftermarket injectors, drop in, will support 345 rear wheel horsepower  $480
Aftermarket injectors and fuel rail, will support 475 rear wheel horsepower  $675
*Some of the above items require additional parts and labor.